DALI Daylight Interface
The DALI Daylight Interface provides a convenient way to configure the parameters of DALI systems via mobile devices with an Android or iOS app. This interface supports setting light levels, circadian curves, sensors, RTC timers, and motion detectors.
Specifications
- Ambient temperature: -20°C to +75°C
- Protection class: IP20
- Max. wire cross section: 1.5mm²
- Mounting: Back box
Function
- Device type: Interface
- Multi-master capable: Yes
Electrical Data
- Supply: From DALI bus
- Current consumption: 4mA
- Output: DALI
Dimensions
- Length: 59mm
- Width: 33mm
- Height: 15mm
- Colour: Grey
Overview
- Interface for changing DALI system parameters via mobile devices
- Android and iOS app available
- All modules within Bluetooth range are displayed in the app
- Suitable for configuring light levels, circadian curve, sensors, RTC timers, and motion detectors
- Pin-protected access
- Multi-master capable, multiple modules and other control devices can be installed on the same DALI line
Installation
- The module is powered directly by the DALI line (current consumption <4 mA)
- Connection to the DALI line is polarity-free and protected against over-voltage (mains voltage)
- Suitable for integration in smart luminaires
- Wiring with solid or fine wire with a conductor cross section of 0.5-1.5 mm²
Compatible Devices
- DALI dimmer / DALI gears
- DALI CDC
- DALI RTC
- DALI CS
- DALI LS
Addressing and Configuration
The DALI Daylight module is detected by the PC software DALI-Cockpit during the addressing procedure. Afterwards, the device can be configured. DALI-Cockpit and DALI-USB interface are used only for configuration and can be removed afterwards.
For each device category (luminaires, DALI CDC, DALI RTC Timer, motion detectors), up to 5 devices that were found during the addressing procedure can be assigned to the DALI Daylight module. Beside each device, the status of the device is shown. For luminaires, manual or sensor-based control can be selected. Depending on this selection, either a luminaire or group of luminaires or a sensor address can be selected. If a sensor is selected, the luminaire address will be copied directly from the sensor settings.
Purchase Order Information
Art. Nr.: 89453863
